Place one rubber washer on each bolt directly under the head and insert the bolts into the bolt holes.
Attaching toilet tank to toilet bowl.
Once you re satisfied it s securely in place connect the water supply tube to the fill valve and flush away.
Hold the head of one bolt still with the screwdriver.
Professional plumber shows you how to fix that leakin.
Be careful not to.
Next put the bolt s tightening nut on the bolt.
Slide one bolt through the holes of the tank and through the holes of the toilet bowl.
Make sure the large diameter rubber tank to bowl or spud washer on the outside of the tank s bottom is firmly seated.
Part of the series.
Replacing the washer between the tank the bowl in a toilet.
More product details close.
Place a second rubber washer on each bolt where they exit from the tank.
Tighten each bolt by alternating from side to side while having a level across the tank to check for level.
Lay the toilet tank flat to insert the bolts from inside.
These bolts travel through a hole at the bottom of the tank and then run through matching holes located in the bowl.
Generally two piece toilets have a set of bolts that attach the tank to the bowl.
Recommended order of sealing and installing a tank to bowl toilet bolt.
Installation is easy simply remove your old cap and nut set the base anti spin washer and old nut then screw on the cap and youre done.
After the bolts are tightened on both sides install your flush valve gasket and proceed to set the tank onto the bowl.
If the bolts extend too far over the top of the washers and nuts cut off the excess with a.
This universal design works with most toilets or bolts.
Choose fluid master smart cap toilet bowl bolt caps to easily cover up bolts in just a few minutes.
Fit the small diameter rubber tank washers into the small tank holes from the inside of the tank then insert the tank bolts.
Gently lower the tank onto the back of the bowl guiding the ends of the tank bolts into the holes.
Place a washer and nut on each toilet bowl bolt and evenly tighten the nuts onto the bolts.
Metal washer optional use only if there is a gap between the tank and the bowl thin metal hex nut optional use only if there is a gap between the tank and the bowl toilet bowl.
Alternate from one side of the toilet to the other as you tighten the nuts a little at a time.